DomeWizard Support, Use Instructions, and Storage
The DomeWizard 3 in 1 cleaning tool is highly effective cleaning tool that can make cleaning cameras extremely safe and easy to do. We recommend reviewing the guidelines before using
BEFORE YOU START
Step 1: Set the cleaning mode. Mode 1 for large domes cameras. Mode 2 for mini or micro dome cameras. Mode 3 for Optical Lenses, Fire Beam Sensors, LED/LCD Public Screens, and Solar Panels.
Step 2: Ensure the area is cleared and all operators are familiar with use before starting.
Step 3: Apply ProClean solution sparilying to microfiber mitt surface. Carefully extend pole sections to desired height and lock clamps while maintaining vertical orientation. Note if cleaning requires horizontal reaching or similar motion use caution and/or add a second operator.
Step 4: Apply cleaning motion and repeat if necessary. Note if the surface is heavily soiled, use optional microfiber towels over the mitt. Lower pole by releasing locking clamps and collapsing pole section by section while maintaining vertical orientation.
Machine or hand wash mitts as needed or reorder mitts. Store in a dry dust free area or location to avoid fouling mitts as debris, sand, or other materials may cause damage to sensitive surfaces.
Do use to clean any type of surface
Do use ProClean solution on non-ammonia solutions
Do replace or wash cleaning mitt when dirty
Do make sure no-one is around or is clear
Do extended it while vertical
Do collapse while vertical
Don’t use with people around
Use caution when using the Dome Wizard around people or traffic
Don’t use when dirty
Don’t use on ladder
Avoid use near overhead power lines
Don’t use on angle